Cisco Systems ASR 1004 quick start Usa

Page 37

Americas Headquarters		Asia Pacific Headquarters		Europe Headquarters
Cisco Systems, Inc.		Cisco Systems, Inc.		Cisco Systems International BV
170 West Tasman Drive		168 Robinson Road		Haarlerbergpark
San Jose, CA 95134-1706		#28-01 Capital Tower		Haarlerbergweg 13-19
USA		Singapore 068912		1101 CH Amsterdam
www.cisco.com		www.cisco.com		The Netherlands
Tel:	408 526-4000	Tel:	+65 6317 7777	www-europe.cisco.com
	800 553-NETS (6387)	Fax:	+65 6317 7799	Tel:	31 0 800 020 0791
Fax:	408 527-0883			Fax:	31 0 20 357 1100

Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the

Cisco Website at www.cisco.com/go/offices.

© 2008 Cisco Systems, Inc. All rights reserved.

Printed in the USA on recycled paper containing 10% postconsumer waste.

OL-15412-03

Image 37

Contents Cisco ASR 1004 Router Document Revision History Documentation and ResourcesPrepare for Equipment Shelf or Tabletop Installation Prepare for InstallationSite Preparation and Unpacking Tools and PartsRack-Mount the Router Prepare for Rack-Mount InstallationAttach the Rack-Mount Brackets-Chassis Front-Mounted Attach the Rack-Mount Brackets-Chassis Rear-Mounted Installing the Cisco ASR 1004 Router in a Four-Post Rack Four-Post Rack InstallationPage Installing a Cisco ASR 1004 Router in a Two-Post Rack Two-Post Rack InstallationAttach the Cable-Management Bracket Chassis Ground Connection Installation Chassis ground connector on the Cisco ASR 1004 Router Console and Auxiliary Port Cable Connections Connect the Router to the NetworkManagement Ethernet Port Cable Connection Cisco ASR1000-RP1 Enet Management Port ConnectorConnect AC Power to the Router Install Cables in the Cable-Management BracketStart the System Connect the Shared Port Adapter CablesCisco ASR 1004 Router AC Power Supply Connect DC Power to the RouterUnit. Statement Installing the DC Ground Lugs Wiring the DC-Input Power Source Cisco ASR 1004 Router DC Power Supply Terminal Block Start the Cisco ASR 1004 Router Verifying Power Supply OperationLED Page Page Using the Console Interface Configure the RouterConfigure Global Parameters Using the Setup Facility OK? No clns routing Tftptimeout Page Save the Running Configuration to Nvram Check the Running Configuration SettingsPerform Other Configuration Tasks Power Off the Cisco ASR 1004 Router After InstallationRemove and Replace a Power Supply Remove and Then Replace a DC Power Supply Page End View All measurements in inches 267 Holes Install and Remove the SPA Interface Processor SIP ASR1000-SIP10 Remove the Shared Port AdapterPage USA