Cisco Systems ASR 1004 quick start Attach the Rack-Mount Brackets-Chassis Rear-Mounted

Page 5

Step 6 To install the Cisco ASR 1004 Router in an equipment rack, see “Four-Post Rack Installation” section on page 6 or “Two-Post Rack Installation” section on page 8.

Note If you install cable management brackets, make certain that the chassis is mounted in the equipment rack first.

Attach the Rack-Mount Brackets—Chassis Rear-Mounted

To install the rack-mount on a Cisco ASR 1004 Router for a rear rack-mount configuration, follow these steps:

Step 1 Locate the threaded holes in the rear sides of the chassis. Make certain that you hold the rear rack-mount bracket with the ear facing outward and towards the rear of the chassis. Align the rack-mount bracket to the side of the router.

Step 2 Position the rear rack-mount bracket top hole with the chassis second top hole in from the back (See Figure 2).

Figure 2 Attaching the Rear Rack-Mount Brackets to Cisco ASR 1004 Router

1 2

1

 

 

 

3

 

0

 

 

 

 

 

280175

 

 

 

4

1

Rear rack-mount bracket ear and holes

3

Rear rack-mount bracket components that slide into rear

 

 

 

bracket which is attached to the chassis

2

Rear rack-mount bracket (first bracket to attach to

4

Rear rack-mount bracket screws

 

chassis)

 

 

Step 3 Insert and tighten the screws. After the bracket is secured to the side of the chassis, slide the two remaining components into the side rack-mount bracket.

Step 4 Repeat Step 1 through Step 3 on the other side of the chassis. Use the screws on each side to secure the rear rack-mount brackets to the chassis.

This completes the procedure for attaching rear rack-mount brackets to the chassis. Continue on to installing the chassis in a rack.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Cisco ASR 1004 Router Document Revision History Documentation and ResourcesPrepare for Equipment Shelf or Tabletop Installation Prepare for InstallationSite Preparation and Unpacking Tools and PartsAttach the Rack-Mount Brackets-Chassis Front-Mounted Prepare for Rack-Mount InstallationRack-Mount the Router Attach the Rack-Mount Brackets-Chassis Rear-Mounted Installing the Cisco ASR 1004 Router in a Four-Post Rack Four-Post Rack InstallationPage Installing a Cisco ASR 1004 Router in a Two-Post Rack Two-Post Rack InstallationAttach the Cable-Management Bracket Chassis Ground Connection Installation Chassis ground connector on the Cisco ASR 1004 Router Console and Auxiliary Port Cable Connections Connect the Router to the NetworkManagement Ethernet Port Cable Connection Cisco ASR1000-RP1 Enet Management Port ConnectorConnect AC Power to the Router Install Cables in the Cable-Management BracketStart the System Connect the Shared Port Adapter CablesCisco ASR 1004 Router AC Power Supply Connect DC Power to the RouterUnit. Statement Installing the DC Ground Lugs Wiring the DC-Input Power Source Cisco ASR 1004 Router DC Power Supply Terminal Block Start the Cisco ASR 1004 Router Verifying Power Supply OperationLED Page Page Configure Global Parameters Using the Setup Facility Configure the RouterUsing the Console Interface OK? No clns routing Tftptimeout Page Perform Other Configuration Tasks Check the Running Configuration SettingsSave the Running Configuration to Nvram Remove and Replace a Power Supply After InstallationPower Off the Cisco ASR 1004 Router Remove and Then Replace a DC Power Supply Page End View All measurements in inches 267 Holes Install and Remove the SPA Interface Processor SIP ASR1000-SIP10 Remove the Shared Port AdapterPage USA
Top Page Image Contents