Cisco Systems ASR 1004 quick start Chassis Ground Connection Installation

Figure 5 Attaching the Cable-Management Bracket to the Cisco ASR 1004 Router

1

3

				C/A
C/A		C/A		A/L
		A	/L	3
A/L				2
		1		C /A
0		C/A		A/L
C	/A	A	/L	3
A	/L			2
		1
0
				C /A
C/A		C/A		A/L
		A	/L	3
A	/L			2
		1		C/A
0		C/A		A/L
C/	A	A	/L	3
A/L				2
		1
0

C/	A		TATUS
A	/L	S
		SPA-4XOC3-POS
C/A			T AT	US
A/L		S
		SPA-4XOC3-POS
C/	A		TATUS
A	/L	S
		SPA-4XOC3-POS
C/	A			US
			T AT
	/L	S
A
		SPA-4XOC3-POS

				C/A
		C/	A	A /L
C/A		A	/L
A	/L			2
		1		C/A
0		C/A		A /L
C	/A	A	/L
A/L				2
		1
0
				C/A
		C/A		A/L
C/A		A/L
A/L				2
		1		C/A
0		C/A		A/L
C/A		A	/L
A/L				2
		1
0

C/	A	TATUS
A	/L	S

		SPA-4XOC3	-POS
3
C/A				T AT	US
	/L		S
A
		SPA-4XOC3	-POS
3
C/	A			TATUS
A	/L		S
		SPA-4XOC3	-POS
3
C/	A				US
	/L		S	T AT
A
		SPA-4XOC3-POS
3

280176

2

							LINK		AUX
									CON
						HD	CARRIER	MGMT	ETHERNET
						USB	BITS
		CRIT
	ACTV	MAJ		O		DF
PWR			AC			DISK
	STBY	MIN			0	1
STAT
	-RP1
ASR1000

1

1

2

Cable-management bracket screws 3 Chassis front rack-mount bracket ear

Cable-management bracket

Step 3 Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the chassis rack-mount (see Figure 5). Figure 4 shows the cable-management brackets attached to the chassis in a rack.

Step 4 Using a Phillips screwdriver and the cable management screw, thread and tighten the screw to the cable-management bracket

Step 5 Repeat steps one through four for the other side of the Cisco ASR 1004 Router.

This completes the procedure for installing the cable-management bracket on a Cisco ASR 1004 Router for a front rack-mount configuration.

Chassis Ground Connection Installation

Before you connect power or turn on power to your router, you must provide an adequate chassis ground (earth) connection for the chassis ground connectors are provided on each Cisco ASR 1004 Router. The chassis ground connector is located on the side of the Cisco ASR 1004 Router.

The following tools, equipment, and supplies necessary to connect the system ground to the chassis:

•Phillips screwdriver

•Dual-lug chassis ground component

•Grounding wire

Figure 6 shows the location of the dual ground lug on the rear of the of Cisco ASR 1004 Router.

10