Chapter 4 System Startup and Basic System Configuration
Powering On the Router and Observing the Boot Process
7.When the Cisco IOS software boots, it polls all other cards in the system, powers them on, and loads the Cisco IOS software they require.
8.The RP waits for all other cards to finish their boot processes.
Powering On the Router and Observing the Boot Process
The first time you start the router, observe the following conditions:
Step 1 Switch on all the circuit breakers that control power to the router.
Step 2 Observe the power entry module LEDs:
•AC
•DC
Step 3 Check the blower module:
•Ensure that the green OK LED is on.
•Listen for the blowers in the blower modules; you should hear them operating immediately. In a noisy environment, the blowers may be difficult to hear. You can place your hand in front of the exhaust vents near the top rear of the chassis to verify that the blower is operating.
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |