Cisco Systems 12810, 12010, 12410 manual Flash Memory Commands, Pwd Command, Cd Command

Chapter 4 System Startup and Basic System Configuration

Using RP Flash Memory Cards

Flash Memory Commands

This section describes console commands that you can use to access the different types of flash memories. Enter these commands from the privileged EXEC mode prompt.

pwd Command

To determine whether the present device you are accessing is the onboard flash SIMM on the RP or a PCMCIA flash memory card, use the pwd command.

This example shows how to access a flash memory card in slot 0 of the RP.

Milo# pwd slot0: Milo#

cd Command

To change access from one type of flash memory device to another, enter the cd device-namecommand.

Where device-namecan be slot0:, slot1:, or bootflash:.

The following example shows the cd command changing access to different devices.

Milo# cd slot1:

Milo# pwd slot1:/

Milo# cd slot0:

Milo# pwd slot0:/

Milo# cd bootflash:

Milo# pwd bootflash:/ Milo#

	Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01		4-49