Cisco Systems 12410, 12010, 12810 manual Milo# copy startup-config slot0myfile2

Chapter 4 System Startup and Basic System Configuration

Using RP Flash Memory Cards

Milo# copy startup-config slot0:myfile2

20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet0):

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCC

Milo#

•The exclamation points (!!!) appear as the file is being copied.

•The C characters signify the calculation of the CRC, which verifies that the file is copied correctly.

Step 3 Enter the dir command to verify that the configuration file is copied correctly to the memory card in slot 0.

Milo# dir slot0:
-#-	-length-	-----	date/time------	name
1	5200084	May	10 1997 19:24:12	gsr-p-mz.112-8

31215 May 10 1997 20:30:52 myfile1

46176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1

51186 May 10 1997 16:56:50 myfile2

9197156 bytes available (11381148 bytes used) Milo#

	Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01		4-59