Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Step 3 Enter the following commands to designate the file named image.new in the memory card in slot 0 as the new default system image for boot purposes:
Milo# configure terminal
Milo(config)# no boot system
Milo(config)# boot system flash slot0:image.new
Milo# copy running-config startup-config
Milo# reload
When the system reloads, it boots the image.new file from the memory card in slot 0.
Copying System Configuration Files Between RP Memory and a Flash Memory Card
If you do not have access to a TFTP server on which you can temporarily store your system configuration file, you can copy the file from RP memory to a flash memory card in slot 0 or slot 1. You can copy your startup configuration file (from NVRAM) or your running configuration file (from DRAM) to the flash memory card.
Use the procedures in the following sections to:
•Copy the configuration file from either NVRAM or DRAM to a flash memory card.
•Copy a configuration file from the flash memory card to NVRAM.
Note You cannot copy files directly into DRAM.
|
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |
|
|
|
|
| ||
|
|
|
| |
|
|
|