Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Copying the Running Configuration File from DRAM to a Flash Memory Card
Use the following procedure to copy the running configuration file from DRAM on the RP to a flash memory card.
Step 1 Enter the copy command in the following form:
copy running-config [slot0:slot1:]filename
Where:
•
•[slot0: slot1:] specifies the destination of the configuration file to be copied.
•filename is the name of the configuration file.
Milo# copy running-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC Milo#
•The exclamation points (!!!) appear as the file is being copied.
•The C characters signify the calculation of the CRC, which verifies that the file is copied correctly.
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |
|