Tension
Lock Knob
Installing Tension
Lever
To install the tension lever:
1.Thread the end of the tension lever into the swivel assembly as shown in Figure 6.
Tension
Lever
Lock
Nut
Swivel
Assembly
Figure 6. Installing tension lever in swivel
assembly.
2.Tighten the lock nut against the swivel assembly to secure the tension lever.
Installing Sanding
Belt
To install the sanding belt:
1.Make sure the tension lock knob is loosened.
2.Move the tension lever into the release posi- tion as shown in Figure 7.
Figure 7. Tension lever in release position.
3.Make sure the arrows on the inside of the belt point in the counter-clockwise direction, and place the sanding belt over both rollers as shown in Figure 8.
Notice Arrow
Direction on
Belt
Figure 8. Installing sanding belt.
|
|
|
G0512 Edge Sander | ||