Installing Back Stop
To install the back stop:
1.Use a machinists square to position the back stop perpendicular to the platen, on the end of the table that is near the ON/OFF switch.
2.Secure the backstop to the table with three #8 x 3⁄4" Phillips head tap screws (as shown in Figure 18).
Back 
Stop
Figure 18. Back stop mounted on table.
Connecting to Dust Collection System
The dust port can be connected to a dust collec- tion system with a 4" hose. However, in order to move the dust from the sander, the dust collec- tion system must be able to move approximately 500 CFM where the hose connects to the dust port.
To connect the dust port to a dust collection system:
1.Slide the 4" hose completely over the dust port as shown in Figure 19.
Figure 20. Dust port connected to dust
collection system.
2.Tighten the hose clamp to ensure a snug, sealed fit.
| G0512 Edge Sander | |
|