Grizzly G0512 Maintenance, General, Lubrication, Bearings, Table Height Lead Screw

Page 25

SECTION 7: MAINTENANCE

Disconnect power to the machine when perform- ing any adjustments or maintenance. Failure to do this may result in seri- ous personal injury.

General

Regular periodic maintenance on your Grizzly Edge Sander will ensure its optimum perfor- mance. Make a habit of inspecting your sander each time you use it. Check for the following con- ditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Any other condition that could hamper the safe operation of this machine.

Table

The laminate surface on the table can be wiped clean with a dry towel or cleaned with a solvent designed to remove wood resins if the table is gummy.

DO NOT expose the underside of the table to water because it may warp.

Lubrication

Bearings

Since all bearings are shielded and permanently lubricated, simply leave them alone until they need to be replaced. DO NOT lubricate them.

Table Height Lead Screw

Wipe off built-up sawdust and lubricate with an occasional shot of white lithium grease. After lubricating, be sure to move the lead screw through the full range of motion that it can travel, so that the grease is spread evenly.

Sanding Belt

The sanding belt should be regularly cleaned as it becomes clogged with sawdust. Clean the sanding belt with PRO STIK® belt cleaners (Model G1511/G1512). Belts that are regularly cleaned have a much longer useful life, than belts that are neglected. See page 31 for more detail on PRO STIK™ belt cleaners.




G0512 Edge Sander	-23-

Image 25

Contents Edge Sander Page Table of Contents Safety Instructions For Power Tools SafetyLength Additional Safety Instructions For Sanders Introduction Amperage Draw Circuit RequirementsPlug Type Circuit Breaker Requirements110V Operation Grounding Extension CordsIdentification Unpacking SET UPG0512 Inventory Hardware Recognition Chart Site Considerations Clean UpFloor Load Working ClearancesInstalling Feet Beginning AssemblyTo install the feet on the sander Installing Sanding Belt Installing Tension LeverTo install the tension lever To install the sanding beltInstall the plug and receptacle now Connecting Plug to CordAttaching Dust Port To attach the dust portTo install the roller guard Installing Roller GuardTest Run & Tracking To test run and track the belt Installing TableAllen wrench placed between platen Connecting to Dust Collection System Installing Back StopTo install the back stop To connect the dust port to a dust collection systemOperations Power SwitchSanding Belt To adjust the tableHeight Model G0512 accepts a 6 x 80 sanding beltTypical edge sanding operation Edge & End SandingContour Sanding General MaintenanceLubrication BearingsAbout Service Service AdjustmentsAdjusting Tensioner Tensioner spring Tracking control bolt Resetting Tensioner Spring TensionTo check the parallel tracking of the sanding belt Parallel Belt TrackingIdler roller adjustment screws G0512 Edge Sander To check the platen-to-idler roller relation- ship Platen-to-Rollers AdjustmentsRemove the sanding belt G0512 Edge Sander Remove the sanding belt and dust port PRO-STICKAbrasive Belt Cleaners Aftermarket AccessoriesReference Info Extra 6 x 80 Belts Grit ModelMachine Data Sheet Breakdown and List Description Symptom Possible Cause Corrective Action Troubleshooting MachineTroubleshooting Sanding G0512 Wiring Diagram Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage #ALL 4ODAYD&ORO