Edge & End Sanding
Keep loose clothing out of the way of machinery and keep hair pulled back during operations!
To perform an edge or end sanding operation:
1.Make sure the vertical tracking on the sand- ing belt is set.
2.Start the sander by pulling the switch up.
3.Support the workpiece against the back stop, keep your fingers away from the moving belt and slowly feed the workpiece into the mov- ing belt, as shown in Figures 23 & 24.
If you must feed a workpiece into the sand- ing belt corner first, feed the trailing corner first. Feeding the leading corner first, could cause the sanding belt to grab the work- piece and jerk it out of your hands.
Figure 23. Typical edge sanding operation.
Figure 24. Typical end sanding operation.
G0512 Edge Sander |