Installing Roller
Guard
To install the roller guard:
1.Place the guard on top of the idler roller and secure it in position with the included small star knob, as shown in Figure 10.
Figure 10. Idler roller guard installed and secured in position with small star knob.
Test Run & Tracking
Before you can install the table, you must run the sander to track the belt. However, you should perform a
To pretrack the belt:
1.Make sure that the sander is disconnect- ed from the power!
2.Loosen the tracking lock knob.
3.Standing in front of the sander, push the sanding belt multiple times along the platen, so that it moves in the direction of operation
4.Adjust the tracking higher or lower as need- ed and continue to rotate the belt by hand.
5.Repeat steps 3 & 4 until the top of the sand- ing belt rides even with the top of the main roller as shown in Figure 11.
Figure 11. Sanding belt even with
top of main roller.
G0512 Edge Sander |