Grizzly instruction manual G0512 Wiring Diagram

Page 39

G0512 Wiring Diagram

Disconnect power from machine before performing any electrical service. Failure to do this will result in a shock hazard, leading to injury or death.

NOTE: THE WIRES FROM THE POWER SUPPLY, EXCEPT THE GREEN GROUND WIRE, ARE INTERCHANGABLE, THEREFORE COLORS ARE NOT SPECIFIED.

110VOLT

MOTOR WIRES

BLACK

YELLOW

WHITE

RED

GREEN (GROUND)

TO 110 VOLT

POWER SUPPLY

220VOLT

MOTOR WIRES

BLACK

YELLOW

RED

WHITE

 

GREEN (GROUND)

 

TO 220 VOLT

Model G0512

POWER SUPPLY

Copyright © May, 2003.

Grizzly Industrial, Inc.Ł

G0512 Edge Sander

-37-

Image 39
Contents Edge Sander Page Table of Contents Safety Instructions For Power Tools SafetyLength Additional Safety Instructions For Sanders Introduction Circuit Breaker Requirements Circuit RequirementsAmperage Draw Plug Type110V Operation Grounding Extension CordsIdentification SET UP UnpackingG0512 Inventory Hardware Recognition Chart Working Clearances Clean UpSite Considerations Floor LoadBeginning Assembly Installing FeetTo install the feet on the sander To install the sanding belt Installing Tension LeverInstalling Sanding Belt To install the tension leverTo attach the dust port Connecting Plug to CordInstall the plug and receptacle now Attaching Dust PortInstalling Roller Guard To install the roller guardTest Run & Tracking To test run and track the belt Installing TableAllen wrench placed between platen To connect the dust port to a dust collection system Installing Back StopConnecting to Dust Collection System To install the back stopOperations Power SwitchModel G0512 accepts a 6 x 80 sanding belt To adjust the tableSanding Belt HeightTypical edge sanding operation Edge & End SandingContour Sanding Bearings MaintenanceGeneral LubricationService Adjustments About ServiceAdjusting Tensioner Tensioner spring Tracking control bolt Resetting Tensioner Spring TensionTo check the parallel tracking of the sanding belt Parallel Belt TrackingIdler roller adjustment screws G0512 Edge Sander To check the platen-to-idler roller relation- ship Platen-to-Rollers AdjustmentsRemove the sanding belt G0512 Edge Sander Remove the sanding belt and dust port Extra 6 x 80 Belts Grit Model Aftermarket AccessoriesPRO-STICKAbrasive Belt Cleaners Reference InfoMachine Data Sheet Breakdown and List Description Symptom Possible Cause Corrective Action Troubleshooting MachineTroubleshooting Sanding G0512 Wiring Diagram Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage #ALL 4ODAYD&ORO