4.Install the front L support with the lock han- dle and two 3⁄8" flat washers as shown in
Figure 14.
Figure 14. Front L support installed.
5.Install the L supports with the lock handles and remaining four 3⁄8" flat washers as shown in Figure 15. The smallest L support at the rear of the machine should be closest to the motor.
Figure 15. Rear L supports installed.
6.Lower the lead screw support all the way down and adjust all of the L support brackets up to approximately the same height. This will prepare the brackets for the table place- ment.
7.Place the table on the supports.
8.Use a 3mm or 1⁄8" Allen wrench as a gauge to position the table evenly away from the plat- en and the idler roller. Do this by placing the Allen wrench as shown in Figure 16, at the three locations shown in Figure 17.
Figure 16. Allen wrench placed between platen
and table.
Figure 17. Three places to ensure the spacing between the sanding belt and the table is even.
9.Clamp the table to the supports or have an assistant hold the table in place, and secure the table to the supports with the #8 x 3⁄4" Phillips head tap screws provided in the hardware bag.
G0512 Edge Sander |