Air Clean Filter, How to clean the air clean filter

2. Lift the anti-mold filter up slightly to disengage it from the protrusions on the unit.

3. Pull downward to remove the filter from the unit.

Cleaning

Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.

How to replace the anti-mold filter

1. Insert the top of the anti-mold filter, and then secure the bottom of the filter with the protrusions on the unit.

2. Close the front panel by pushing the center of the front panel and then pressing both edges until the panel clicks into place.

Anti-mold filter

Protrusions

Anti-Mold Filter

The anti-mold filter behind the front panel should be checked and cleaned at least once every two weeks.

How to remove the anti-mold filter

1. Grasp both ends of the front panel and pull forward and up to open the front panel.

Front panel

CAUTION

1. Never use solvents, or harsh chemicals when cleaning the indoor unit. Do not wipe the plastic casing using very hot water.

2. Some metal edges and the fins are sharp and may cause injury if handled improperly; be especially careful when you clean these parts.

3. The internal coil and other components of the outdoor unit must be cleaned every year. Consult your dealer or service center.

If these parts are stained, use a clean cloth moistened with a mild liquid detergent. When cleaning the grille, be careful not to force the vanes out of place.

2 1 2

Air Clean Filter

The air clean filter removes dust and dirt from the air, and reduces odors and smoke from tobacco.

This air clean filter cannot remove harmful gases or vapors nor ventilate air in the room. You must open doors or windows frequently when you use gas or oil heating appliances. Otherwise there is a risk of suffocation in extreme cases.

How to install the air clean filter

The air clean filter needs to be installed behind the anti-mold filter.

Anti-mold filter

Air clean filter

Air filter holder

1.Open the front panel and remove the anti-mold filter.

2.Remove the air filter holder from the anti-mold filter.

3.Install the air clean filter in the air filter holder.

4.Install the air filter holder to the anti-mold filter, remount the anti- mold filter, and close the front panel.

How to clean the air clean filter

•In general, the filter should be sucked to remove dust in low fan speed of a vacuum cleaner once every three months.

•If there is heavily grime on the filter, soak the filter in lukewarm water with neutral detergent diluted 1:500 for 1 to 2 minutes then wash it.

•Rinse the filter in clean water, then let it dry on the towel in room temperature.

NOTE

•Do not bend nor give excessive force onto the air clean filter.

•If the filter surface is heavily blocked with dirt or damaged, replace it with new one. Purchase a replacement filter at your local dealer. (model STK-FDXB)

Cleaning the main unit and remote control unit

•Wipe clean using a soft, dry cloth.

•To remove stubborn dirt, moisten a cloth in warm water no hotter than 104 °F, wring thoroughly, and then wipe.

•The front panel can be removed in order to wash it with water.

Removing and remounting the front panel

Removing

Open the front panel until it is nearly horizontal, grasp the sections near the front panel arms on both sides, and then remove the panel by pushing the arms towards the outside while pulling the panel towards you.

If the front panel is difficult to remove, grasp both ends of it and lift it up slightly.

Move it to the left and disengage the left arm, then move it to the right and disengage the right arm.

Front panel

Arm

OI-149-16-EG