Sanyo KHS3682 + CH3682 How to Install the Indoor Unit, Remove the Rear Panel from the Unit

3. How to Install the Indoor Unit

3-1. Remove the Rear Panel from the Unit

(1)Remove and discard the set screw on the rear panel. (Fig. 6)

(2)Press the 2 ▲ marks on the frame cover and disengage the stationary tabs from the frame. (Fig. 7a)

(3)Remove the rear panel by grasping the sections shown in Fig. 7b and pulling it in the direction shown by the arrow.

NOTE

Tubing can be extended in 6 directions as shown in Fig. 8. Select the direction you need providing the shortest run to the outside unit.

●When left tubing is to be done, switch the drain hose and drain cap. (For details, refer to “Switching drain hose and drain cap” on page 20.)

3-2. Make a Hole

(1)Place the rear panel from the indoor unit on the wall at the location selected. Make sure the panel is horizontal, using a carpenter’s level or tape measure to measure down from the ceiling. Wait until after cutting the hole before attaching the rear panel to the wall.

(2)Determine which side of the unit you should make the hole for tubing and wiring. (Fig. 9)

NOTE

In the case of left-rear tubing, use the measurement points 6-7/32" (158 mm) from the marked position on the rear panel for precise placement of the hose outlet. (Fig. 9)

(3)Before making the hole, check carefully that no studs or pipes are directly run behind the spot to be cut.

CAUTION	Also avoid areas where elec-
	trical wiring or conduits are
	located.

The above precautions are also applicable if tubing goes through the wall in any other location.

6-7/32"	5-3/16"
(158 mm)	(132 mm)

Fig. 9

Set screw only for transportation

Fig. 6

Rear panel

marks

Fig. 7a

Rear panel

Fig. 7b

Rear panel

Fig. 7c

		Right-rear
Left	Left-rear	tubing
tubing	tubing	(recommended)
		Right
Left-downward		tubing
		Right-downward
tubing
		tubing

Fig. 8

12