7. HIGH POWER Mode
HIGH POWER mode can be used to increase the output of the indoor unit for all operation modes except automatic operation.
Press the HIGH POWER button while operation.
The 
mark appears in the display.
To cancel, press HIGH POWER button again.
•When the HIGH POWER button is pressed, the unit operates at maximum output for 30 minutes, regardless of the desired temperature. The fan speed is 1 step above “High”.
•HIGH POWER Mode cannot be used when the operation mode is Automatic Operation.
•QUIET Mode and HIGH POWER Mode cannot be used at the same time.
NOTE
•Pressing the MODE selector button cancels HIGH POWER mode.
•When set to High fan speed during heating operation, the fan runs
at High fan speed even though the 
mark is displayed.
•Depending on the operating conditions, the fan speed may be increased by a small amount only.
8. LED CLEAN Mode
In LED CLEAN mode, a UV
Press the LED CLEAN button while operation.
The 
mark appears in the display.
To cancel, press the LED CLEAN button again.
•When the LED CLEAN button is pressed, the UV
NOTE
•Pressing the MODE selector button cancels LED CLEAN mode.
•Do not open the front panel while the LED CLEAN lamp on the display is on.
•Depending on the room brightness, light from the LED CLEAN lamp may reflect inside the air conditioner and be visible. This is not a malfunction.
9. UNOCCUPIED Mode
Unoccupied mode is used to prevent the room temperature from decreasing too much (or increasing too much) when no one is in the room, and operate automatically to save energy.
Press the UNOCCUPIED button. The 
mark appears in the display.
To release the unoccupied function, press the UNOCCUPIED button again.
Unoccupied Indication
Unoccupied | Unoccupied | Status | |
Function | Indication | ||
| |||
|
|
| |
OFF | no display | The unoccupied function is not set. | |
|
|
| |
|
| The unoccupied function is now | |
|
| being set, and under Heating (or | |
| flashing | Cooling) operation. | |
ON |
| ||
|
| ||
| Although the unoccupied function is | ||
|
| ||
|
| set, not under Heating (or Cooling) | |
| lighting | operation. | |
|
| ||
|
|
|
NOTE
Even if Unoccupied Mode is ON, it will be disabled if the air conditioner is in operation.
•Unoccupied Function can be set and released through all operational modes, regardless of whether the air conditioner is operating or not.
•If the Unoccupied Function is ON and the remote control unit is used to turn the air conditioner OFF (including OFF TIMER), the air conditioner will turn off, but depending on the room temperature, Heating or Cooling Operation will automatically begin.
•When the Unoccupied Function is in operation and the ON/OFF operation button is pressed, operation will restart based on the settings input before the air conditioner was turned off.
11 | |
|