FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
1. Switch trigger
2. Lock button
2
1 
1 |
|
2 | 3 |
| |
015161 |
|
CAUTION:
1.Red indicator
2.Button
3.Battery cartridge
015162
To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger, push in the lock button and then release the trigger.
To stop the tool from the locked position, pull the switch trigger fully, and then release it.
NOTE:
• | Even with the switch on and motor running, the bit |
•Always switch off the tool before installing or removing of the battery cartridge.
•Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator on the upper side of the button, it is not locked completely.
CAUTION:
•Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you.
•Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly.
Switch action
CAUTION:
•Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
•Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool.
| does not rotate. Push the tool forward to engage |
| the clutch. |
• | The tool automatically stops if the motor keeps |
| rotating for about 6 minutes. |
Push drive mode
1 | 1. Button | |
2. Mode indicator | ||
| ||
| 2 | |
015173 |
|
This tool has push drive mode. In this mode, the tool cuts off power to the motor to save the battery power at idle.
To select push drive mode, pull the trigger slightly, then release it and quickly press the button. The mode indicator will then light up.
Once push drive is activated, pull the switch trigger and then push the lock button. Apply pressure to the bit and the motor will start rotating. Further pressure engages the clutch and the bit will start rotating. In push drive mode, the motor and the driver bit will only rotate by applying pressure.
NOTE:
•If the tool does not run for about 8 hours in push drive mode with the trigger locked on, tool is shutdown. In such a case, release and pull the trigger again for restarting.
5