Sanyo KS1872 How to Install the Outdoor Unit, Wiring Instructions for the Outdoor Unit

Page 17

4. How to Install the Outdoor Unit

First refer to Section 2. Installation Site Selection.

4-1. Wiring Instructions for the Outdoor Unit

Regulations on wire size differ from locality to locality. For field wiring requirements, please refer to your local elec- trical codes. Make sure that the installation fully complies with all local and national regulations.

(1)Remove access panel “C”. (Fig. 46)

(2)Connect the inter-unit and power supply line accord- ing to the drawing on the panel side.

(3)Be sure to size each wire allowing approx. 4"

(10 cm) longer than the required length for wiring. Store excess wiring inside the cabinet.

(4)When connections are completed, check that all connections are correct as shown in the wiring sys- tem diagram on panel side.

(5)Be sure to ground the unit according to your local codes.

Lock nut

Cabinet

Terminal block

Conduit plate

Access panel C

Plug	Inter unit	Power supply
	(Conduit)	(Conduit)

Fig. 46

Image 17

Contents Contents Installation Instructions…In a Ceiling or Wall For safe installation and trouble-free operation, you must…In a Room …In Moist or Uneven LocationsAccessories Supplied with Unit Table Tools Required for Installation not suppliedGeneral Optional Copper Tubing KitIndoor Unit Installation Site SelectionAdditional Materials Required for Installation C2472, CL2472 Outdoor UnitC1872, CL1872 Baffle Plate for the Outdoor Unit CLxx models only Trical wiring or conduits are How to Install the Indoor UnitRemove the Rear Panel from the Unit Make a HoleIf Block, Brick, Concrete or Similar Type Wall Install the Rear Panel on the WallIf Wooden Wall How to replace the grille Remove the Grille to Install the Indoor UnitHow to remove the grille Shape the Indoor Side Tubing Wiring Instructions General precautions on wiringAWG Recommended Wire Length and DiameterWiring Instructions for Inter-unit Connections For stranded wiring How to connect wiring to the terminal For Indoor UnitFor Outdoor Unit For solid core wiring or F-cable Right-side tubing MountingLeft-side tubing Switching drain hose and drain capDrain hose Drain capTubing and wiring to the out Do not supply power toTo unmount indoor unit Unit or operate it until allWiring Instructions for the Outdoor Unit How to Install the Outdoor UnitUse of the Flaring Method Flaring Procedure with a Flare ToolRefrigerant Tubing Insulation of Refrigerant Tubing Connecting Tubing between Indoor and Outdoor UnitsFinishing the Installation Air Purging Hex wrench before Be sure to completely insertHow to Test Run the Air Conditioner Pump Down Basic Functions of the Service ValvesMounting on a Wall Remote Control Unit Installation PositionTo take out the remote control unit, pull it forward Address Setting of the Remote Control Unit Address Switch