Specifications
Motor | 120 V~ / 60 Hz / 15 A | |||
n0 4100/min | ||||
|
| |||
Arbor Diameter | 1” | |||
Blade Type | General Purpose with | |||
Carbide Tips | ||||
|
| |||
Blade Diameter | 12” | |||
|
| At 90°: 3.93” Deep x 12.5” | ||
Cutting Capacity | Wide. | |||
At 45°: 1.97” Deep x 8.27” | ||||
|
| |||
|
| Wide. | ||
Positive Table Stops | 0°, 15°, 22.5°, 30° and 45° | |||
both Right and Left | ||||
Positive Bevel Stops | 0° and 45° Left only | |||
Blade Tilt Range | 0° - 45° right and left miter | |||
0° - 45° compound | ||||
|
| |||
Scale | 1° per scale mark | |||
|
| E 105017 | ||
|
|
|
| |
|
|
|
|
LASER LIGHT
DO NOT STARE INTO BEAM
Max. Output: 1mW,
Wavelength: 650 nm
CLASS II LASER PRODUCT
This product complies with
21 CFR 1040.10 and 1040.11
3491 Mission Oaks Blvd.,
Camarillo, CA, USA, 93011
Manufacture Date: ___________, _______
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
List of contents
Description | Qty |
Compound Sliding Miter Saw | 1 |
12” Carbide Tipped Blade | 1 |
Table Extensions | 2 |
Dust Collection Bag | 1 |
Wrench | 1 |
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
WARNING To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
Attaching the Extension Supports
1.Insert the ends of the Extension Sup- ports into the holes in the sides of the Base. Tighten the Wing Screws to hold the Extensions in place. The upper edge of the Extensions will be level with the surface of the saw. This provides a wider base for the work material to rest on.
Attaching the Dust Collection Bag
2.The Dust Collection Bag slips over the Dust Outlet behind the Blade Housing Assembly. Sawdust created by cutting is captured in the bag.
REV 08f
SKU 96698 | For technical questions, please call | Page 10 |