Black & Decker BDCR20B Important Safety Instruction for Battery Packs, Read all Instructions

Page 5

foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

• DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

• These chargers are not intended for any uses other than charging designated Black +Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

• Do not expose charger to rain or snow.

• Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.

• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

• An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

• Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

• Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

• Do not operate charger with damaged cord or plug — have them replaced immediately.

• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

• Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

• Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

Important Safety Instruction for Battery Packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

• Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

• If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

• Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

• Charge the battery packs only in Black+Decker chargers.

• DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

• Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer). WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Thank you for choosing Black+Decker 20v max* reciprocating sawSave all warnings and instructions for future reference Work Area Safety Electrical safety Use power tools only with Specific Safety RulesSymbols Important Safety Instructions for Battery ChargersRead all Instructions Important Safety Instruction for Battery PacksLeaving the battery in the charger Charging ProcedureInstallation and Removal of the Battery Pack Important charging notesPage Trigger Switch Maintenance TroubleshootingAccessories PROJECT TIPSLatin America This warranty Service Information Limited Two-Year Home Use WarrantyRbrc Seal Free warning labelScie alternative De 20 v max Sécurité du lieu de travail Utilisation et entretien du bloc-piles Consignes de sécurité particulièresConserver CES Directives AvertissementMise EN Garde dans Avertissement risque deMise EN Garde risque de Avertissement pour un Recommandations en matière de rangementLire toutes les directives Avertissement ne jamaisPage Remarques importantes pour le chargement Procédure de chargeFonctionnement Avertissement toujours DétenteCoupe du bois figure H Coupe à ras figure GCoupe de métaux figure Découpe en poche Bois seulement Figure JDépannage Problème Cause possible Solution possibleEntretien Maximiser la durée de vie duLe sceau Rbrc EntretienPage Pautas DE SEGURIDAD/DEFINICIONES Sierra alternativa De 20 v mÁxSeguridad eléctrica Seguridad en el área de trabajoUso y mantenimiento de la herramienta eléctrica Normas específicas de seguridadAdvertencia Riesgo de Advertencia USE SiempreAdvertencia Para un Precaución Riesgo deLea todas las instrucciones No incinere el paquete de bateríasAdvertencia Nunca intente Advertencia Peligro deRecomendaciones Con respecto al Almacenamiento Procedimiento de cargaPage Instrucciones de operación Notas importantes sobre la cargaPalanca de liberación de la abrazadera de la hoja Advertencia Peligro de corteCortes en madera Figura H Corte al ras Figura GCortes en metal Figura Cortes internos Madera solamente Figura JMantenimiento LubricaciónGarantía limitado de dos años para uso en el hogar El sello RbrcInformación de mantenimiento Años limitado DE Garantia América Latina esta garantía noEsta Garantia no Aplica Cuando Años DE GarantiaFerre Pat de Puebla, S.A. de C.V Htas. Portátiles de ChihuahuaFernando González Armenta Perfiles y Herramientas de Morelia

BDCR20B specifications

The Black & Decker BDCR20B is a versatile and powerful cordless rechargeable drill that meets the needs of both DIY enthusiasts and professionals. One of its standout features is its 20V MAX lithium-ion battery, which provides a longer runtime and holds a charge four times longer than traditional NiCad batteries. This ensures that users can complete their projects without frequent interruptions for battery charging.

A notable characteristic of the BDCR20B is its compact design, making it easy to maneuver in tight spaces. Weighing only a few pounds, it is lightweight and easy to handle, reducing fatigue during extended use. Its ergonomic handle provides a comfortable grip, enabling users to maintain control and precision while working on various tasks.

Equipped with a built-in LED work light, the BDCR20B enhances visibility in low-light conditions. This feature is particularly beneficial for users who often find themselves working in dimly lit areas, ensuring that they can see their work clearly without straining their eyes. The drill also boasts a high-performance motor that delivers a speed of up to 650 RPM, allowing for efficient drilling and driving into a wide variety of materials, including wood, metal, and plastic.

Versatility is another key aspect of the BDCR20B, as it comes with a 0-gear chuck that enables quick and easy bit changes. Users can effortlessly switch between different drilling and fastening tasks, making it an ideal tool for a range of applications, from assembling furniture to hanging shelves. The drill's 11-position clutch provides precise control over torque, preventing overdriving and stripping of screws, which results in a more polished and professional finish.

In terms of construction, the BDCR20B is built to endure. Its rugged exterior and robust design make it a durable companion for even the most demanding projects. Furthermore, the drill's battery is compatible with other tools in the 20V MAX system, offering added convenience for users who own multiple Black & Decker tools.

In summary, the Black & Decker BDCR20B combines power, efficiency, and versatility in a compact design. With its long-lasting battery, high-performance motor, and user-friendly features, it is an excellent choice for anyone looking to enhance their toolkit with a reliable cordless drill. Whether tackling everyday tasks or engaging in more complex projects, the BDCR20B is equipped to handle the job with ease.
Top Page Image Contents