3.Pull off the battery and separate it from the 3D Eyewear by cutting off the wires, one by one, with scissors.
Insulate the wire parts of the removed battery with cellophane tape.
Battery
NOTE
•Take sufficient care when performing this work so as not to injure yourself.
•Do not damage or dismantle the battery.
ENGLISH
Troubleshooting/Q&A
Check the followings first. If they do not solve the problem, please contact the place of purchase.
Cannot register a 3D Eyewear to TV.
►► Does the TV support on this 3D Eyewear?
Use the 3D Eyewear with compatible TVs. (
page 2)
►► Did you allow more than 1 minute to elapse after setting the unit to the device registration mode?
The registration is automatically released if you allow more than 1 minute to elapse. Set the registration with the television and connected 3D Eyeware placed as close to each other as possible.
Images are not 3D.
►► Is the TV has been registered with the 3D Eyewear?
Perform the registration with the TV to see. (
page 9)
►► Is the 3D Eyewear mode set to 3D?
Slide the tab once to the MODE position to change the mode between 3D and 2D.
►► Are the image settings switched to 3D images?
Refer the television operating instructions.
12