54
Set the Center Value of the Volume in the TEST mode.
7
8
9 In the TEST mode, check to see if the Volume Value varies smoothly in accordance with the steering wheel operation.
Turn on power.
FIG. 9. 1 a
"D" CUT FACE
SCREW (2)
M4 X 12, w/flat & spring washers
4The V.R. is on the VR BASE (a white, plastic made part). Loosen the 2 screws which secure the VR BASE and adjust the angle and appropriateness of gear mesh by moving the VR BASE.
5Adjust to an appropriate mesh by securing the Steering Wheel in the direction allowing the car to advance straight forward and ensuring the "D" CUT FACE of the Volume shaft is oriented as shown.
6Tighten the 2 screws to secure the VR BASE.