Sharp HT-SB500 Maintenance, Error indicators and warnings, Cleaning the cabinet, Display Meaning

HT-SB500

ENGLISH

References

E-19

Maintenance

Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth.

Caution:

Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet finish.

Do not apply oil to the inside of each component. It may cause malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the following messages are displayed on the speaker.

Display		Meaning
or	or	Malfunction of the surround
		circuit. Place the speaker away
		from noise source and plug the
		AC power lead into another AC
or		outlet. (*)
		When there is no input signal.
		Play back the connected
		equipment.
		Nonstandard signal. Cannot be
or		recognized.
		Signals other than DOLBY
		DIGITAL, DTS, Linear PCM
		cannot be recognized.
		Poor connection of the digital
		audio input terminal.
		Turn off the unit and check if the
(Display blinks continuously)		cable is connected properly.
		When the protection circuit is
Power indicator		activated.
(blinks red)

(*): Should the same message appear even if the speaker is unplugged and plugged in, or is set to the stand-by mode and on again, contact your local dealer where you purchased the speaker.