3.3 SYSTEM SETUP
Before using the HJZTP keyboard it must be
Pressing and holding the ‘lock’ key and entering XXXX (code not shown) on the numeric keypad, will display the keyboard setup menu, as shown below:
A | U X | = | S E T | L | O C | K | = | E N | D |
K | E Y | B R D | D V R / | M U | X | P R T C | L | ||
‘KEYBRD’ will be flashing. Use the joystick left and right or the ‘F3’ (‘◄’) and ‘F4’ (‘►’) keys (or ‘camera’ and ‘preset’ buttons), to select the required option. Pressing ‘aux’ will then enter the required menu.
3.3.1Keyboard Type
The keyboard can be set as a master keyboard or one of 3 slave keyboards. The default setting is as a master keyboard.
If there is only one keyboard in the system or the keyboard is to be the one which is connected to the domes and DVRs / multiplexers, then the keyboard must be set as a master keyboard. Other keyboards in the system must be set as slaves. Up to three slave keyboards can be connected to the master keyboard, each slave keyboard must have a different slave keyboard number.
To set the keyboard type, select ‘KEYBRD’ in the keyboard setup menu. The following menu will be displayed:
A | U X | = | S E | T | L O C K | = | E | N D |
M S T R |
| S L V | 1 | S L V 2 | S L V | 3 | ||
If the keyboard has not been set- up before ‘MSTR’ will be flashing, otherwise the keyboards current setting will be flashing. Use the joystick left and right or the ‘F3’ (‘’) and ‘F4’ (‘’) keys (or ‘camera’ and ‘preset’ keys) to select the required option, then press ‘aux’. The keyboard type selected will be displayed for 1 second to confirm the selection, as shown below (n is the Slave number):
S L A V E | n | K E Y B O A R D |
Or:
M 
A 
S 
T 
E 
R 
K 
E 
Y 
B 
O 
A 
R 
D 
Once the required keyboard type has been selected, press ‘lock’ to exit the menu.
Rev. 1.01 | 13 | 900.0570 |
|
|