Logical Solutions SCS-R manual Administering Users, User Setup

SECURE CONSOLE SERVERS User Setup

8 Administering Users

The following commands are used to change settings for Users. You can define as many Users as you wish, up to the memory capacity of the system. The limiting factor when it comes to Users is not the number of users but rather the number of simulta- neous sessions invoked by any number of users (250 sessions maximum).

8.1 User Setup

Each user account must have a unique name, and each has its own password. Each User account has the following parameters:

Parameter

name

password

port range or port group

(used below)

ESCAPE_SEQ

BREAK_SEQ

ALLOW_CLEAR

ALLOW_CONNECT

ALLOW_MONITOR

Constraints

A unique user name made up of contiguous characters. Cannot be renamed. This name will be displayed at the command prompt when a user has logged in.

Linux password for this user account.

Default is set to access all ports in the SCS chassis (1-16, 1-32 or 1-48). Ports can be assigned individually (1), in a contiguous range (2-7), in random ports (3,6,9,15) or any combination of the above (1,4-7,12,15-16) of valid port numbers for that chassis.

Escape sequence. Default is “Esc-A”. Displayed in ASCII (x1bA)

Break sequence. Default is “Esc-B”. Displayed in ASCII (x1bB)

Range or group of Ports for which this User account can Clear the Port Buffers.

Range or group of Ports to which this User account can connect

Range or group of Ports which the User can monitor

tel (203) 647-8700 Page 67 Product Manual - MAN-000001C