Dell 2700W manual Settings Description Available Settings Default Setting

Table 7. Settings (continued)

Description	Available Settings	Default Setting
Battery Saving Mode	[Disabled] [10%] [20%] [30%]...[100%]	Disabled
	The UPS output is turned off in five minutes if the
	UPS is on battery and output power is below the
	selected level.
On Battery Notice Delay	[0] [1s] [2s]...[99s]	0s
	The UPS issues a “UPS on battery” notice in the
	specified number of seconds after the UPS starts to
	discharge the batteries.
Site Wiring Fault Alarm	[Enabled] [Disabled]	Enabled for low
		voltage models;
		Disabled for all other
		models
Bypass Voltage Low Limit	[-6%] [-7%]...[-20%] of nominal	-15% of nominal
	The Bypass operation is disabled if the measured
	bypass voltage level is below the nominal output
	voltage (-15%).
	NOTE: The Qualify Bypass setting may overrule the
	Bypass Voltage Low Limit setting.
Bypass Voltage High Limit	[+6%] [+7%]...[+20%] of nominal	+10% of nominal
	The Bypass operation is disabled if the measured
	bypass voltage level is above the nominal output
	voltage (+10%).
	NOTE: The Qualify Bypass setting may overrule the
	Bypass Voltage High Limit setting.

Operation 43