DCN Wireless Installation and User Instructions Contribution Devices
en 76
14DCN-WDU Wireless Discussion Units
14.1Introduction
With the wireless discussion units, the delegates and chairmen can make contributions to a discussion. The chairmen can also use their wireless discussion units to monitor and control a discussion.
14.2Controls, connectors and indicators
14.2.1 Top
The top of the wireless discussion units (refer to figure
14.1) contains:
1Microphone socket - Connects a
discussion unit (refer to chapter 15).
2Loudspeaker - Gives the audio signal from the floor to the delegate or the chairman. When the
microphone is activated, the signal of the loudspeaker is muted.
3 Volume buttons - Change the volume level of the signal that is sent to the headphones.
4Microphone buttons - Activate or deactivate the microphone. Each microphone button has a LED that shows the condition of the microphone. The mode of the wireless discussion unit (refer to section 14.8.4) gives the type and number of microphone buttons that you must install in the wireless discussion unit.
5Voting buttons - Operate the wireless discussion unit. Each voting button has a yellow LED.
14.2.2 Left and right sides
The left and right sides of the wireless discussion units (refer to figure 14.2) contain:
6Headphones socket - Connect headphones to the wireless discussion unit (refer to section 14.7.1).
14.2.3 Bottom side
The bottom side of the wireless discussion units (refer to figure 14.3 and figure 14.4) contains:
7Battery pack container - Contains the
8Configuration switches - Configure the wireless discussion unit (refer to section 14.3) and set the mode of the wireless discussion unit (refer to section 14.4).
9
10Power supply socket - Connects a
14.2.4 Rear side
The rear side of the wireless discussion units (refer to figure 14.5) contains:
11Status LEDs - Give information about the condition of the wireless discussion unit (refer to section 14.8).