HP J3250M manual Status Port Status, Port Status Settings

Managing Switches

Switch Status

Status - Port Status

The Port Status page (switches only) displays the operational status of each switch port. The settings can be changed in the Configuration - Port Configuration page.

The Port Status settings are described in the following table.

Table 7-1. Port Status Settings

	Setting	Description
	Port	The port number.
	Port Type	The network type of each switch port, for example, 100TX.
	Enabled	Whether the port is enabled or disabled.
	Link Status	The port’s current operational status. Up means the port is working
		correctly. Down means the port is disabled.
	Current Mode	The operational mode of the port.
		• 10/100 Base TX - Can be 10 Mbits half or full duplex or 100 Mbits
		half or full duplex.
		• 100 Base FX - Can be 100/full duplex or 100/half duplex.
		• Gigabit - Can only be 1000 full duplex.
Switches
	Flow Control	– On - Flow control is enabled.
		Indicates the current state of flow control for this port.
Managing		• 10/100TX, 10 FL, 100 FX:
		– Off - Flow control is disabled (default).
		• Gigabit:
		– On (TX, RX) - Flow control is enabled on transmit and
		receive.
		– On (RX) - Flow control on receive only.
		– Off (default) - Flow control is disabled.
	Bcast Limit (not	The Broadcast Limit, expressed as a percentage of broadcast
	available on	packets relative to the theoretical limit. Any broadcast or multicast
	the HP J3298 A or HP	traffic exceeding this limit will be dropped. A value of zero
	J3299A)	indicates that no limit is to be applied. Values range from 0-99.

7-4