HP J3250M manual Network Parameters, HP OpenView Device Symbols, HP Hub & Switch

HP Hub & Switch Management Admin

HP Admin Parameters

The parameters are briefly described below. For more information, see the HP

Admin online help.

Network Parameters

Network parameters enable you to set values and behavior for network device communication and Closeup View activity. The parameters for network device communication are described in the following table.

Management Admin

HP Hub & Switch

Figure 10-1. Setting Network Parameters

Table 10-1. Network Parameters

Parameter	Description
SNMP Max Retries	Specifies the number of times will retry an SNMP request to
	get a response. The range is 1-5 times. The default is 3.
SNMP Timeout	Specifies the time (in seconds) that HP Hub & Switch
	Management will wait for a reply on each request. The range
	is 1-6 seconds. The default is 5.

HP OpenView Device Symbols

There are two states for an OpenView device symbol on an OpenView map, explodable and executable. When the device symbol is in the explodable state (no box appears around it) and you double-click on it, a submap showing

10-6