HP J3250M manual Running HP Hub & Switch Management, Starting the Manager Application

4

Running HP Hub & Switch Management

This chapter describes how to start and stop HP Hub & Switch Management. It includes the following topics:

■Starting the Manager Application

■Verifying Installation of the Manager Product Set

■Stopping and Restarting the Manager Application

Note: Before you begin, you should ensure that the network devices are properly set up for IP operation. For information on setting up HP network devices, see Appendix A.

Starting the Manager Application

The entire product set that you have installed is started as one application, “the manager”, on your management station. In other words, HP Hub & Switch Management starts along with Network Node Manager.

Starting HP OpenView

Do the following steps to start your product.

1.Add /opt/OV/bin to your path using one of the commands below. Note that you only need to do this the first time you start the HP OpenView manager software.

For These Shells	Use These Commands
/bin/ksh or /bin/	PATH=$PATH:/opt/OV/bin:/usr/sbin
sh	export PATH
/bin/csh�	setenv PATH “$PATH:/opt/OV/bin:/usr/
	sbin”

Running HP Hub & Switch Management

4-1