HP P4459A manual Retract the anti-tip foot, if desired

Page 36

HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide

Plugging in the other end of the power cord will apply power to the switch. You can do either of the following:

•Connect the other end of the power cord to the power receptacle on the rack, which means you will hot-plug devices to the switch.

•Wait to plug in the other end of the power cord, so that you can con- nect devices to the switch before you power it.

2.If you purchased a filler panel separately, install the filler panel on the front of the rack by pressing it into place, as shown in Figure 16.

Figure 16: Installing the Filler Panel (Shown for HP Rack System/E and HP Rack System/U Racks)

Right Front Rack Column

Filler Panel

Right Rear Rack Column

Switch

Left Front Rack Column

Left Rear Rack Column

3.Retract the anti-tip foot, if desired.

28

Image 36

Contents HP Part Number Audience Assumptions Safety Instructions Symbols Used on EquipmentSymbols in Text Contents Appendix B Regulatory Information Preface Related PublicationsRelated Web Sites Chapter Introducing the HP P4459A Port Fibre Loop Switch Fibre Loop Switch FeaturesGbic Ports Front View of the Fibre Loop Switch Front Panel LEDsLEDs Switching Operation Switching Using Fibre Channel ProtocolFibre Channel Arbitration in the Fibre Loop Switch Fibre Loop Switch Initialization Introducing the HP P4459A 8-Port Fibre Loop Switch Page Installing the Fibre Loop Switch Unpacking the Fibre Loop SwitchInstalling and Removing GBICs Fibre Loop Switch Installing a GbicRemoving a Gbic Remove any cables attached to the GbicRack Mounting the Fibre Loop Switch Rack InstallationRack Installation Basics Mounting in HP Systems Racks Tools Required Preparation Marking Holes and Attaching Barrel Nuts on HP Systems Racks Mark the Rack Column Holes Place the Barrel Nuts on the Rack ColumnsInstalling the Fibre Loop Switch Attach the Sleeves to the Front Rack Columns Identify the six Torx screws Attaching Sleeves to an HP Systems Rack Installing the Fibre Loop Switch Attach the Switch Rails to the Switch Chassis Securing the Switch Rails to the Switch Install the switch Installing the Switch into an HP Systems Rack Complete the Installation Connect the appropriate AC power cord to the switchRetract the anti-tip foot, if desired Powering up a System Cabling for the Fibre Loop SwitchCopper cable requirements for the Fibre Loop Switch Chapter Fibre Loop Switch Troubleshooting General Maintenance ConsiderationsTroubleshooting the Switch Reading the LED IndicatorsReading The Power, Fault, and Initialization LEDs Reset Button ConnectionsTemperature Control Fibre Channel CablesFans Filler PanelPage Appendix a Fibre Loop Switch Functional Specifications SwitchingPhysical Specifications Environmental SpecificationsElectrical Specifications LED SpecificationsFibre Channel Communications Regulatory CertificationVcci V3 1997, Class a Page Appendix B Regulatory Information Regulatory NoticesElectromagnetic Compliance Class a Accessories Class a EquipmentFor products labeled as Class a Class a Warning Radio Frequency Emissions Warning for Accessories Declaration of Conformity US and EU Declaration of ConformityRegulatory Notices Product Safety Laser Safety Germany Class Laser Product Lasser Klasse 1 Produkt Appendix C Warranty and Support Hardware Accessories Limited WarrantyHewlett-Packard Hardware Accessories HP Repair and Telephone Support Third-Party Hardware ProductsCanada Other CountriesWorld Wide Web Page Glossary Transmission sent to all NPorts on a network ElectroMagnetic Compatibility FC-PH Fpga Time delay of data traffic through a network or a switch Lilp Lpsm OFC Fibre Channel Arbitrated Loop that is connected to a fabric SAN Physical or logical layout of nodes on a network