HP P4459A manual Declaration of Conformity US and EU

Page 53

Regulatory Information

Declaration of Conformity (US and EU)

DECLARATION OF CONFORMITY

according to ISO/IEC Guide 22 and EN 45014

Manufacturer's/Supplier Name:		Hewlett-Packard Company
Manufacturer's/Supplier Address:		10955 Tantau Avenue
declares, that the product		Cupertino, Ca 95014 USA

Product Name:		HP 8-Port Fibre Loop Switch
Model Number(s):		P4459A
Product Options:		All
conforms to the following Product Specifications:
Safety:	IEC 60950: 1991 +A1, A2, A3, A4/ EN 60950: 1992 + A1, A2, A3, A4, A11
	GB4943-1995
EMC:	EN 55022: 1998/CISPR 22:1997, ITE Radiated and Conducted Emissions
	CFR 47 Part 15, Subpart B, Unintentional Radiators, Radiated and Conducted Emissions
	EN 61000-3-2: 1995 +A1: 1998, Harmonic Current Emissions
	EN 61000-3-3: 1995, Voltage Fluctuation and Flicker

EN55024: 1998/CISPR 24: 1997

EN 61000-4-2/IEC 61000-4-2: 1995, ESD

EN 61000-4-3/IEC 61000-4-3: 1995, Radiated Immunity

EN 61000-4-4/IEC 61000-4-4: 1995, Fast Transient/Burst

EN 61000-4-5/IEC 61000-4-5: 1995, Surge

EN 61000-4-6/IEC 61000-4-6: 1996, Conducted Immunity

EN 61000-4-11/IEC 61000-4-11: 1994, Voltage Dips and Interruptions

Supplementary Information:

1)The product was tested in a typical configuration.

2)The product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

ŸThis device may not cause harmful interference, and

ŸThis device must accept any interference received, including interference that may cause undesired operation.

The product herewith complies with the requirements of the following directives and carries the CE-marking accordingly:

-EMC Directive 89/336/EEC including Ce Marking Directive 93/68/EEC

-Low Voltage Directive 73/23/EEC

Cupertino, March 1, 2001

North American Contact: Hewlett-Packard Company 3000 Hanover Street

Palo Alto, CA 94304 650-857-1501

European Contact: Your local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH

Department ZQ/Standards Europe, Herrenberger Straße 130, D-7030 Böblingen, (FAX: + 49-7031-14-3143) Quality Management Services & Systems Phone ++613 9272 8355

45

Image 53

Contents HP Part Number Audience Assumptions Symbols Used on Equipment Safety InstructionsSymbols in Text Contents Appendix B Regulatory Information Related Publications PrefaceRelated Web Sites Gbic Ports Chapter Introducing the HP P4459A Port Fibre Loop SwitchFibre Loop Switch Features Front Panel LEDs Front View of the Fibre Loop SwitchLEDs Switching Using Fibre Channel Protocol Switching OperationFibre Channel Arbitration in the Fibre Loop Switch Fibre Loop Switch Initialization Introducing the HP P4459A 8-Port Fibre Loop Switch Page Unpacking the Fibre Loop Switch Installing the Fibre Loop SwitchInstalling a Gbic Installing and Removing GBICs Fibre Loop SwitchRemove any cables attached to the Gbic Removing a GbicRack Installation Rack Mounting the Fibre Loop SwitchRack Installation Basics Mounting in HP Systems Racks Tools Required Preparation Marking Holes and Attaching Barrel Nuts on HP Systems Racks Place the Barrel Nuts on the Rack Columns Mark the Rack Column HolesInstalling the Fibre Loop Switch Attach the Sleeves to the Front Rack Columns Identify the six Torx screws Attaching Sleeves to an HP Systems Rack Installing the Fibre Loop Switch Securing the Switch Rails to the Switch Attach the Switch Rails to the Switch ChassisInstall the switch Installing the Switch into an HP Systems Rack Connect the appropriate AC power cord to the switch Complete the InstallationRetract the anti-tip foot, if desired Cabling for the Fibre Loop Switch Powering up a SystemCopper cable requirements for the Fibre Loop Switch General Maintenance Considerations Chapter Fibre Loop Switch TroubleshootingReading the LED Indicators Troubleshooting the SwitchReading The Power, Fault, and Initialization LEDs Connections Reset ButtonFibre Channel Cables Temperature ControlFans Filler PanelPage Switching Appendix a Fibre Loop Switch Functional SpecificationsPhysical Specifications Environmental SpecificationsLED Specifications Electrical SpecificationsFibre Channel Communications Regulatory CertificationVcci V3 1997, Class a Page Electromagnetic Compliance Appendix B Regulatory InformationRegulatory Notices For products labeled as Class a Class a AccessoriesClass a Equipment Class a Warning Radio Frequency Emissions Warning for Accessories Declaration of Conformity Declaration of Conformity US and EURegulatory Notices Product Safety Laser Safety Germany Class Laser Product Lasser Klasse 1 Produkt Hewlett-Packard Hardware Accessories Appendix C Warranty and SupportHardware Accessories Limited Warranty Third-Party Hardware Products HP Repair and Telephone SupportCanada Other CountriesWorld Wide Web Page Glossary Transmission sent to all NPorts on a network ElectroMagnetic Compatibility FC-PH Fpga Time delay of data traffic through a network or a switch Lilp Lpsm OFC Fibre Channel Arbitrated Loop that is connected to a fabric SAN Physical or logical layout of nodes on a network