HP P4459A manual Mounting in HP Systems Racks

Page 22

HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide

instructions that come with your rack or HP NetServer, or refer to the following web site:

http://www.hp.com/racksolutions

Note: The installation instructions that follow use “left” and “right” to refer to rack columns as viewed from the rear of the rack.

Figure 5 and Figure 6 present a visual summary of the switch’s rack-mounting hardware.

Figure 5: Mounting in HP Systems Racks

Left Front	Right Front Rack Column
Rack Column

Sleeves

Right Rear Rack Column

Switch

Left Rear Rack Column

Rails

14

Image 22

Contents HP Part Number Audience Assumptions Safety Instructions Symbols Used on EquipmentSymbols in Text Contents Appendix B Regulatory Information Preface Related PublicationsRelated Web Sites Fibre Loop Switch Features Chapter Introducing the HP P4459A Port Fibre Loop SwitchGbic Ports Front View of the Fibre Loop Switch Front Panel LEDsLEDs Switching Operation Switching Using Fibre Channel ProtocolFibre Channel Arbitration in the Fibre Loop Switch Fibre Loop Switch Initialization Introducing the HP P4459A 8-Port Fibre Loop Switch Page Installing the Fibre Loop Switch Unpacking the Fibre Loop SwitchInstalling and Removing GBICs Fibre Loop Switch Installing a GbicRemoving a Gbic Remove any cables attached to the GbicRack Mounting the Fibre Loop Switch Rack InstallationRack Installation Basics Mounting in HP Systems Racks Tools Required Preparation Marking Holes and Attaching Barrel Nuts on HP Systems Racks Mark the Rack Column Holes Place the Barrel Nuts on the Rack ColumnsInstalling the Fibre Loop Switch Attach the Sleeves to the Front Rack Columns Identify the six Torx screws Attaching Sleeves to an HP Systems Rack Installing the Fibre Loop Switch Attach the Switch Rails to the Switch Chassis Securing the Switch Rails to the SwitchInstall the switch Installing the Switch into an HP Systems Rack Complete the Installation Connect the appropriate AC power cord to the switchRetract the anti-tip foot, if desired Powering up a System Cabling for the Fibre Loop SwitchCopper cable requirements for the Fibre Loop Switch Chapter Fibre Loop Switch Troubleshooting General Maintenance ConsiderationsTroubleshooting the Switch Reading the LED IndicatorsReading The Power, Fault, and Initialization LEDs Reset Button ConnectionsFans Temperature ControlFibre Channel Cables Filler PanelPage Physical Specifications Appendix a Fibre Loop Switch Functional SpecificationsSwitching Environmental SpecificationsFibre Channel Communications Electrical SpecificationsLED Specifications Regulatory CertificationVcci V3 1997, Class a Page Regulatory Notices Appendix B Regulatory InformationElectromagnetic Compliance Class a Equipment Class a AccessoriesFor products labeled as Class a Class a Warning Radio Frequency Emissions Warning for Accessories Declaration of Conformity US and EU Declaration of ConformityRegulatory Notices Product Safety Laser Safety Germany Class Laser Product Lasser Klasse 1 Produkt Hardware Accessories Limited Warranty Appendix C Warranty and SupportHewlett-Packard Hardware Accessories Canada HP Repair and Telephone SupportThird-Party Hardware Products Other CountriesWorld Wide Web Page Glossary Transmission sent to all NPorts on a network ElectroMagnetic Compatibility FC-PH Fpga Time delay of data traffic through a network or a switch Lilp Lpsm OFC Fibre Channel Arbitrated Loop that is connected to a fabric SAN Physical or logical layout of nodes on a network