HP P4459A manual Safety Instructions, Symbols Used on Equipment

Page 3

HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide

Safety Instructions

The following sections describe the symbols used on the fibre loop switch and within this guide and also provides safety information about the product:

Symbols Used on Equipment

Symbols in Text

Grounding Requirements

Symbols Used on Equipment

The following table describes the symbols that are used on the fibre loop switch.

Any surface of area of the equipment marked with these symbols indicates the presence of electrical shock hazards. Enclosed area contains no operator serviceable parts.

Warning: To reduce risk of injury from electrical shock hazards, do no open this enclosure.

This product is a safety Class I product which has a protective earthing terminal. There must be an uninterrupted safety earth ground from the main power source to the product’s input wiring terminal, power cord(s), or supplied power cord set(s). Whenever it is likely that the protection has been impaired, disconnect the power cord(s) until the ground has been restored.

APPARATEN SKALL ANSLUTAS TILL JORDAT

NÄTTUTAG.

iii

Image 3
Contents HP Part Number Audience Assumptions Symbols Used on Equipment Safety InstructionsSymbols in Text Contents Appendix B Regulatory Information Related Publications PrefaceRelated Web Sites Chapter Introducing the HP P4459A Port Fibre Loop Switch Fibre Loop Switch FeaturesGbic Ports Front Panel LEDs Front View of the Fibre Loop SwitchLEDs Switching Using Fibre Channel Protocol Switching OperationFibre Channel Arbitration in the Fibre Loop Switch Fibre Loop Switch Initialization Introducing the HP P4459A 8-Port Fibre Loop Switch Page Unpacking the Fibre Loop Switch Installing the Fibre Loop SwitchInstalling a Gbic Installing and Removing GBICs Fibre Loop SwitchRemove any cables attached to the Gbic Removing a GbicRack Installation Rack Mounting the Fibre Loop SwitchRack Installation Basics Mounting in HP Systems Racks Tools Required Preparation Marking Holes and Attaching Barrel Nuts on HP Systems Racks Place the Barrel Nuts on the Rack Columns Mark the Rack Column HolesInstalling the Fibre Loop Switch Attach the Sleeves to the Front Rack Columns Identify the six Torx screws Attaching Sleeves to an HP Systems Rack Installing the Fibre Loop Switch Securing the Switch Rails to the Switch Attach the Switch Rails to the Switch ChassisInstall the switch Installing the Switch into an HP Systems Rack Connect the appropriate AC power cord to the switch Complete the InstallationRetract the anti-tip foot, if desired Cabling for the Fibre Loop Switch Powering up a SystemCopper cable requirements for the Fibre Loop Switch General Maintenance Considerations Chapter Fibre Loop Switch TroubleshootingReading the LED Indicators Troubleshooting the SwitchReading The Power, Fault, and Initialization LEDs Connections Reset ButtonFiller Panel Temperature ControlFibre Channel Cables FansPage Environmental Specifications Appendix a Fibre Loop Switch Functional SpecificationsSwitching Physical SpecificationsRegulatory Certification Electrical SpecificationsLED Specifications Fibre Channel CommunicationsVcci V3 1997, Class a Page Appendix B Regulatory Information Regulatory NoticesElectromagnetic Compliance Class a Accessories Class a EquipmentFor products labeled as Class a Class a Warning Radio Frequency Emissions Warning for Accessories Declaration of Conformity Declaration of Conformity US and EURegulatory Notices Product Safety Laser Safety Germany Class Laser Product Lasser Klasse 1 Produkt Appendix C Warranty and Support Hardware Accessories Limited WarrantyHewlett-Packard Hardware Accessories Other Countries HP Repair and Telephone SupportThird-Party Hardware Products CanadaWorld Wide Web Page Glossary Transmission sent to all NPorts on a network ElectroMagnetic Compatibility FC-PH Fpga Time delay of data traffic through a network or a switch Lilp Lpsm OFC Fibre Channel Arbitrated Loop that is connected to a fabric SAN Physical or logical layout of nodes on a network