HP Scitex LX800 Industrial manual Tri-phase AC Power Cord

Page 29

The AC power cords (tri-phase and single-phase) have to be screwed to the bottom terminals of the switch. Add adequate ferrules on power cord cable terminations. In total there are 6 terminals to attach wires, and only 5 of them are to be used. They are labeled (from left to right): L1, L2, L3, (blank), L0 and N. Each wire must be securely attached to the terminals of the power switch.

Label on Switch

Wire

Power Cord

 

 

 

L1

Phase

Tri-phase

 

 

 

L2

Phase

Tri-phase

 

 

 

L3

Phase

Tri-phase

 

 

 

Blank

 

 

 

L0

Phase

Single-phase

 

 

 

N

Neutral

Single-phase

 

 

 

ENWW

Tri-phase AC Power Cord 25

Image 29
Contents HP Designjet L65500 Printer & HP Scitex LX Printer family Trademarks Table of contents Prepare for printing Configure the electrical systemPurge the ink system Prepare the printer General safety guidelines Safety precautionsHeat hazard Heavy substrate hazard Label Explanation Emergency stop buttons Manpower required Installation guide overviewTools required for installation IntroductionL65500 only Inbox contentEnww Unload the crate Receive the shipmentRemove the crate packaging Move the printer over rampsRemove the printer from the pallet Enww Lift the printer to a second floor using a crane Enww Choose the final position Set up the printer in the final positionHow to push the printer Set up the printer in the final position Remove additional packaging Enww Enww Enww Enww Lower the feet Requirements Connect the power cablesTri-phase AC Power Cord Tri-phase Power Cord attachment Tri-phase AC Power Cord Protective Earth attachment Protective Earth conductors groundingInstall the fuses and power jumper Configure the electrical systemInstall the power jumpers Install the fusesHeating Module Configuration Choose delta or star Y configurationCuring Module Configuration Check connections Check resistancesGround check Connect mains powerPower on the printer Power on the printer Enww Make sure that the printer is ready to be turned on Turn power onConfigure the voltage Purge the ISM tubes Purge the ink systemInk Supply Legend Enww Ink Supply Legend Enww Problems with the ink sensor value Enww Enww Fill the intermediate ink tanks Purge the tubes from the ISM to the printheads Enww Enww Enww Prepare the printer Install the printhead cleaning roll and aerosol filtersInstall the printhead cleaning roll Install the printhead cleaning roll and aerosol filters Install the aerosol filters Manpower Tools Time Person T20, T30 Phillips screwdriver Enww Create a folder called OutJobs Enww Enww Configure the printer’s IP address Prepare for printing Install the printheadsEnww Enww Callme@HP Setup Process Antivirus Registration Web Cam InstallationLoad a substrate Connect the air supplyCustomers RIP for use with the HP Designjet L65500 Printer Configure the RIPHP Scitex Onyx RIP HP Scitex Caldera RIP Install the coversInstall the covers Print the HP test images Print the HP test images Prepare the HP Internal Print Server Japan and Russia only Update the rate indexChange the power settings Enww Set a blank screen saver Configure the hard diskEnable scheduled defragmentation Configure the proxy Configure visual effectsInstall the HP Internal Print Server Enww Manually configure the printer’s IP address Select IPV4 Settings Select Config Method Enww Change the Windows Vista language Enww
Related manuals
Manual 16 pages 36.28 Kb