HP Scitex LX800 Industrial manual Fill the intermediate ink tanks

Page 49

Fill the intermediate ink tanks

1.From the front panel, select Purge and Setup Menu > Fill intermediate tanks.

2.Install all the intermediate ink tanks, apply the labels (match them to the labels on the printer) and confirm that they are installed from the front panel.

The printer unfolds the intermediate ink tanks. This process takes approximately 25 minutes.

NOTE: During this time, you can install the printhead cleaner roll, aerosol filters, HP Internal Print Server and switch. See Install the printhead cleaning roll and aerosol filters on page 50 and Install the computer, monitor, LAN switch, tray, keyboard and mouse on page 53.

3.When the printer finished unfolding the intermediate ink tanks, press OK to continue.

The printer fills the intermediate ink tanks. This takes a few minutes.

4.When the process is finished, check that the ink cartridge LED is green and press any key to continue.

ENWW

45

Image 49

Contents HP Designjet L65500 Printer & HP Scitex LX Printer family Trademarks Table of contents Purge the ink system Prepare the printer Configure the electrical systemPrepare for printing General safety guidelines Safety precautionsHeat hazard Heavy substrate hazard Label Explanation Emergency stop buttons Manpower required Installation guide overviewTools required for installation IntroductionL65500 only Inbox contentEnww Unload the crate Receive the shipmentRemove the crate packaging Move the printer over rampsRemove the printer from the pallet Enww Lift the printer to a second floor using a crane Enww How to push the printer Set up the printer in the final positionChoose the final position Set up the printer in the final position Remove additional packaging Enww Enww Enww Enww Lower the feet Tri-phase AC Power Cord Connect the power cablesRequirements Tri-phase Power Cord attachment Tri-phase AC Power Cord Protective Earth attachment Protective Earth conductors groundingInstall the fuses and power jumper Configure the electrical systemInstall the power jumpers Install the fusesHeating Module Configuration Choose delta or star Y configurationCuring Module Configuration Check connections Check resistancesPower on the printer Connect mains powerGround check Power on the printer Enww Make sure that the printer is ready to be turned on Turn power onConfigure the voltage Purge the ISM tubes Purge the ink systemInk Supply Legend Enww Ink Supply Legend Enww Problems with the ink sensor value Enww Enww Fill the intermediate ink tanks Purge the tubes from the ISM to the printheads Enww Enww Enww Install the printhead cleaning roll Install the printhead cleaning roll and aerosol filtersPrepare the printer Install the printhead cleaning roll and aerosol filters Install the aerosol filters Manpower Tools Time Person T20, T30 Phillips screwdriver Enww Create a folder called OutJobs Enww Enww Configure the printer’s IP address Prepare for printing Install the printheadsEnww Enww Callme@HP Setup Process Antivirus Registration Web Cam InstallationLoad a substrate Connect the air supplyCustomers RIP for use with the HP Designjet L65500 Printer Configure the RIPHP Scitex Onyx RIP HP Scitex Caldera RIP Install the coversInstall the covers Print the HP test images Print the HP test images Prepare the HP Internal Print Server Japan and Russia only Update the rate indexChange the power settings Enww Set a blank screen saver Configure the hard diskEnable scheduled defragmentation Configure the proxy Configure visual effectsInstall the HP Internal Print Server Enww Manually configure the printer’s IP address Select IPV4 Settings Select Config Method Enww Change the Windows Vista language Enww

Related manuals

Manual 16 pages 36.28 Kb