HP Scitex LX800 Industrial Turn power on, Make sure that the printer is ready to be turned on

Page 39

7.Check that the Protective Bonding Conductor (green-and-yellow grounding cable) is well attached to the curing system (at the resistor connection).

Turn power on

1.Make sure that the printer is ready to be turned on.

Make sure that the emergency stop buttons are not pressed.

Make sure the ACB-1, ACB-2 and ACB-3 circuit breakers located on the electrical cabinet door are enabled (in the UP position).

Make sure the electronics box switch is turned on.

Have you removed all the additional packaging?

Have you lowered the feet?

Is the correct power jumper installed?

Are the delta/star terminal blocks configured correctly?

Are the carriage access door and sliding door closed?

Are all tools and other objects clear from the printer?

Make sure that no people are touching the printer.

2.Turn the power switch ON.

3.Go the front panel and see if it is on. If it is not on, press and hold the Power key for a few seconds to start the printer.

ENWW	Power on the printer 35

Image 39

Contents HP Designjet L65500 Printer & HP Scitex LX Printer family Trademarks Table of contents Configure the electrical system Purge the ink system Prepare the printerPrepare for printing General safety guidelines Safety precautionsHeat hazard Heavy substrate hazard Label Explanation Emergency stop buttons Introduction Installation guide overviewManpower required Tools required for installationL65500 only Inbox contentEnww Unload the crate Receive the shipmentRemove the crate packaging Move the printer over rampsRemove the printer from the pallet Enww Lift the printer to a second floor using a crane Enww Set up the printer in the final position How to push the printerChoose the final position Set up the printer in the final position Remove additional packaging Enww Enww Enww Enww Lower the feet Connect the power cables Tri-phase AC Power CordRequirements Tri-phase Power Cord attachment Tri-phase AC Power Cord Protective Earth attachment Protective Earth conductors groundingInstall the fuses and power jumper Configure the electrical systemInstall the power jumpers Install the fusesHeating Module Configuration Choose delta or star Y configurationCuring Module Configuration Check connections Check resistancesConnect mains power Power on the printerGround check Power on the printer Enww Make sure that the printer is ready to be turned on Turn power onConfigure the voltage Purge the ISM tubes Purge the ink systemInk Supply Legend Enww Ink Supply Legend Enww Problems with the ink sensor value Enww Enww Fill the intermediate ink tanks Purge the tubes from the ISM to the printheads Enww Enww Enww Install the printhead cleaning roll and aerosol filters Install the printhead cleaning rollPrepare the printer Install the printhead cleaning roll and aerosol filters Install the aerosol filters Manpower Tools Time Person T20, T30 Phillips screwdriver Enww Create a folder called OutJobs Enww Enww Configure the printer’s IP address Prepare for printing Install the printheadsEnww Enww Callme@HP Setup Process Connect the air supply Web Cam InstallationAntivirus Registration Load a substrateCustomers RIP for use with the HP Designjet L65500 Printer Configure the RIPHP Scitex Onyx RIP HP Scitex Caldera RIP Install the coversInstall the covers Print the HP test images Print the HP test images Prepare the HP Internal Print Server Japan and Russia only Update the rate indexChange the power settings Enww Set a blank screen saver Configure the hard diskEnable scheduled defragmentation Configure the proxy Configure visual effectsInstall the HP Internal Print Server Enww Manually configure the printer’s IP address Select IPV4 Settings Select Config Method Enww Change the Windows Vista language Enww

Related manuals

Manual 16 pages 36.28 Kb