2.The customer should have the correct air supply with the correct connection. Use the adaptor to connect the airgun to the customer air supply.
Configure the RIP
A Raster Image Processor (RIP) should be run on a separate computer, In this section we describe how to configure the RIP correctly for use with the printer.
●L65500 only: RIP software is not provided with the printer, and cannot be installed on the same computer as the HP Internal Print Server.
●LX800/LX600 only: The RIP software is sold with the printer:
◦HP Scitex Onyx RIP Software CQ756A
◦HP Scitex Caldera RIP Software CQ755A
The customer's RIP for use with the HP Designjet L65500 Printer
The customer's RIP must be configured correctly to work with the HP Designjet L65500 Printer. Because HP cannot support the customer's RIP, any troubleshooting must be done using the documentation and service that accompany the RIP. However, generally three tasks must be done:
1.Configure the IP address or network name of the HP Designjet L65500 Printer.
2.Configure the RIP to recognize the shared output folder with the HP Internal Print Server.
3.Make any additional configurations required by the RIP.
64 Chapter 9 Prepare for printing | ENWW |