SMC Networks 2.4GHz/5GHz manual Initial Setup through the CLI, Initial Configuration

Initial Configuration

Initial Setup through the CLI

The wireless bridge provides access to the CLI through a Telnet connection. You can open a Telnet session by performing these steps:

1.From the host computer, enter the Telnet command and the IP address of the wireless bridge unit (default 192.168.2.2 if not set via DHCP).

2.At the prompt, enter “admin” for the user name.

3.The default password is “smcadmin”.

The CLI will display the “Dual Outdoor#” prompt to show that you are using executive access mode (i.e., Exec).

Username: admin

Password:

Dual Outdoor#

For a full description of how to use the CLI, see “Using the Command Line Interface” on page 7-1. For a list of all the CLI commands and detailed information on using the CLI, refer to “Command Groups” on page 7-9.

Initial Configuration Steps

Setting the Country Code – Regulations for wireless products differ from country to country. Setting the country code restricts the wireless bridge to use only the radio channels and power settings permitted in the specified country of operation. If the wireless bridge unit is shipped with a preset country code, you are not permitted to change it, as required by country regulations. If the unit is set to the default “99,” you must set the country code to the country of operation.

5-2