SMC Networks 2.4GHz/5GHz manual Command not shown in example

System Configuration

authentication. To view the current 802.11g security settings, use

the show interface wireless a or show interface wireless g

command (not shown in example).

AP(config)#interface wireless g		7-99
Enter Wireless	configuration commands, one per line.
AP(if-wireless	g)#authentication open	7-109
AP(if-wireless	g)#encryption 128	7-110
AP(if-wireless	g)#wpa-clients required	7-116
AP(if-wireless	g)#wpa-mode pre-shared-key	7-117
AP(if-wireless	g)#wpa-psk-type alphanumeric	7-119
AP(if-wireless	g)#wpa-preshared-key ASCII asecret	7-118
AP(if-wireless	g)#end
AP(config)#no 802.1X		7-51
AP(config)#no mac-authentication		7-59

CLI Commands for WPA over 802.1X Security – From the 802.11a or 802.11g interface configuration mode, use the authentication command to set the access point to “Open System.” Use the WEP encryption command to enable all types of encryption. Use the wpa-clientscommand to set WPA to be required or supported for clients. Use the wpa-modecommand to enable WPA dynamic keys over 802.1X. Set the broadcast and multicast key encryption using the multicast-ciphercommand. Then set 802.1X to required, and disable MAC authentication. To view the current 802.11g security settings, use the show interface wireless g command (not shown in example).

AP(config)#interface wireless g		7-99
Enter Wireless	configuration commands, one per line.
AP(if-wireless	g)#authentication open	7-109
AP(if-wireless	g)#encryption 128	7-110
AP(if-wireless	g)#wpa-clients required	7-116
AP(if-wireless	g)#wpa-mode dynamic	7-117
AP(if-wireless	g)#multicast-cipher TKIP	7-114
AP(if-wireless	g)#end
AP(config)#802.required		7-51
AP(config)#no mac-authentication		7-59

6-86