Align Antennas

RSSI BNC

Connection

Voltmeter

2.Pan the antenna horizontally back and forth while checking the RSSI voltage. If using the pole-mounting bracket with the unit, you must rotate the mounting bracket around the pole. Other external antenna brackets may require a different horizontal adjustment.

3.Find the point where the signal is strongest (highest voltage) and secure the horizontal adjustment in that position.

Note: Sometimes there may not be a central lobe peak in the voltage because vertical alignment is too far off; only two similar peaks for the side lobes are detected. In this case, fix the antenna so that it is halfway between the two peaks.

4.Loosen the vertical adjustment on the mounting bracket and tilt the antenna slowly up and down while checking the RSSI voltage.

5.Find the point where the signal is strongest and secure the vertical adjustment in that position.

6.Remove the voltmeter cable and replace the RSSI connector cover.

4-11

Page 63
Image 63
SMC Networks 2.4GHz/5GHz manual Rssi BNC