Chapter 4 Hardware Installation
Before mounting antennas to set up your wireless bridge links, be sure you have selected appropriate locations for each antenna. Follow the guidance and information in Chapter 2, “Wireless Link Planning.”
Also, before mounting units in their intended locations, you should first perform initial configuration and test the basic operation of the wireless bridge links in a controlled environment over a very short range. (See the section “Testing Basic Link Operation” in this chapter.)
The wireless bridge includes its own bracket kit for mounting the unit to a 1.5 to 2 inch diameter steel pole or tube. The
Hardware installation of the wireless bridge involves these steps:
1.Mount the unit on a wall, pole, mast, or tower using the mounting bracket.
2.Mount external antennas on the same supporting structure as the bridge and connect them to the bridge unit.
3.Connect the Ethernet cable and a grounding wire to the unit.
4.Connect the power injector to the Ethernet cable, a local LAN switch, and an AC power source.
