Wireless Interface Commands
Example
AP#show interface ethernet Ethernet Interface Information
========================================
IP Address | : 192.168.2.2 |
Subnet Mask | : 255.255.255.0 |
Default Gateway | : 192.168.1.253 |
Primary DNS | : 192.168.1.55 |
Secondary DNS | : 10.1.0.55 |
Admin status | : Up |
Operational status | : Up |
========================================
AP#
Wireless Interface Commands
The commands described in this section configure connection parameters for the wireless interface.
Command | Function | Mode | Page |
|
|
|
|
interface wireless | Enters wireless interface | GC | |
| configuration mode |
|
|
|
|
|
|
description | Adds a description to the wireless | ||
| interface |
|
|
|
|
|
|
ssid | Configures the service set identifier | ||
|
|
|
|
closed system | Prohibits access to clients without a | ||
|
|
| |
|
|
|
|
speed | Configures the maximum data rate | ||
| for transmitting unicast packets on |
|
|
| the wireless interface |
|
|
|
|
|
|
channel | Configures the radio channel | ||
|
|
|
|
turbo | Configures the 802.11a radio to use a | ||
| faster proprietary modulation mode |
|
|
|
|
|
|
Configures the rate at which beacon | |||
| signals are transmitted from the |
|
|
| wireless bridge |
|
|
|
|
|
|