Troubleshooting
3.If the wireless bridge cannot be configured using Telnet, a web browser, or SNMP software:
•Be sure to have configured the wireless bridge with a valid IP address, subnet mask and default gateway.
•Check that you have a valid network connection to the wireless bridge and that the Ethernet port or the wireless interface has not been disabled.
•If you are connecting to the wireless bridge through the wired Ethernet interface, check the network cabling between the management station and the wireless bridge.
•If you cannot connect using Telnet, you may have exceeded the maximum number of concurrent Telnet sessions permitted (i.e, four sessions). Try connecting again at a later time.
4.If all other recovery measures fail, and the wireless bridge is still not functioning properly, take any of these steps:
•Reset the wireless bridge’s hardware using the CLI, web interface, or through a power reset.
•Reset the wireless bridge to its default configuration.
5.If you forgot or lost the password:
•Contact Technical Support.
