Command Line Interface
gateway if you are managing the wireless bridge from a different IP subnet. For example:
AP#configure AP(config)#interface ethernet
After you configure the wireless bridge with an IP address, you can open a Telnet session by performing these steps.
1.From the remote host, enter the Telnet command and the IP address of the device you want to access.
2.At the prompt, enter the user name and system password. The CLI will display the “AP#” prompt to show that you are using executive access mode (i.e., Exec).
3.Enter the necessary commands to complete your desired tasks.
4.When finished, exit the session with the “quit” or “exit” command.
After entering the Telnet command, the login screen displays:
Username: admin
Password:
AP#
Note: You can open up to four sessions to the device via Telnet.
