Command Line Interface

Note: Before enabling VLANs on the wireless bridge, you must configure the connected LAN switch port to accept tagged VLAN packets with the wireless bridge’s native VLAN ID. Otherwise, connectivity to the wireless bridge will be lost when you enable the VLAN feature.

The VLAN commands supported by the wireless bridge are listed below.

Command

Function

Mode

Page

 

 

 

 

vlan

Enables a single VLAN for all traffic

GC

7-124

 

 

 

 

native-vlanid

Configures the native VLAN for the

GC

7-125

 

access point

 

 

 

 

 

 

vlan

This command enables VLANs for all traffic. Use the no form to disable VLANs.

Syntax

vlan enable no vlan

Default

Disabled

Command Mode

Global Configuration

Command Description

Changing the VLAN status of the wireless bridge forces a system reboot.

When VLANs are enabled, the wireless bridge tags frames received from wireless interface with the configured native

VLAN ID.

Traffic entering the Ethernet port must be tagged with a VLAN ID that matches the wireless bridge’s native VLAN ID.

7-124

Page 294
Image 294
SMC Networks 2.4GHz/5GHz manual Syntax Vlan enable no vlan Default, Command Description