Ethernet Interface Commands

Related Commands

show interface ethernet (page 7-96)

ip address

This command sets the IP address for the (10/100Base-TX) Ethernet interface. Use the no form to restore the default IP address.

Syntax

ip address <ip-address> <netmask> <gateway> no ip address

ip-address- IP address

netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.

gateway - IP address of the default gateway

Default Setting

IP address: 192.168.2.2

Netmask: 255.255.255.0

Command Mode

Interface Configuration (Ethernet)

Command Usage

DHCP is enabled by default. To manually configure a new IP address, you must first disable the DHCP client with the no ip dhcp command.

7-93

Page 263
Image 263
SMC Networks 2.4GHz/5GHz manual Ip address ip-address netmask gateway no ip address