HP MSR1000 Router manual Replacement procedure, Replacing a SIC, Replacing a Dsic

Page 30

Replacement procedure

CAUTION:

SICs and DSICs are not hot swappable. Make sure the router is powered off before replacing a SIC or DSIC.

Replacing a SIC

1.Loosen the captive screws on the SIC.

2.Gently pull the SIC out along the slide rails.

3.Install a new SIC. For the installation procedure, see "Installing the router." If you do not install a SIC, install a filler panel and tighten the screws.

Figure 26 Removing a SIC

Figure 27 Installing a filler panel

Replacing a DSIC

1.Loosen the captive screws on the DSIC.

2.Gently pull the DSIC out along the slide rails.

If you need to install a DSIC or SICs, see "Installing the router" for the installation procedure.

26

Image 30

Contents HP MSR1000 Routers Page Contents Page Safety symbols Preparing for installationSafety recommendations General safety recommendationsExamining the installation site Temperature and humidityCleanness Cooling system ESD preventionLightning protection Rack-mountingInstallation accessories Installation checklistRequirements Result Components when observing or moving a removed Requirements Result Installing the router Installation prerequisitesInstallation flowchart Installation flow Installing the router Installing the router in a rackMounting the router on a workbench Marking the positions of cage nuts Page Grounding the router Grounding the router through the rackGrounding the router through the rack Grounding the router with a grounding strip Installing an interface module Installing a SICInstalling a Dsic Removing the filler panelConnecting interface cables Fasten the captive screws to secure the DsicConnecting a console cable Attaching a USB deviceLogging in through the console port Setting terminal parameters Connection descriptionSetting the serial port used by the HyperTerminal connection HyperTerminal window Powering on the router Connecting an AC power cordVerifying the installation Verifying before power-onPowering on the router Displaying boot informationYou can now configure the router Configuring basic settings for the routerExamining the router after power-on Press Enter, and the following prompt appearsReplacement procedure Replacing a SICReplacing a Dsic Removing a Dsic System configuration problems TroubleshootingPower supply failure No terminal displayNo response from the serial port Restoring the factory settingsGarbled terminal display ScenarioReset button usage guidelines MSR1002-4 Appendix a Chassis views and technical specificationsChassis views Following figures are for illustration onlyTechnical specifications MSR1003-8MSR1002-4 MSR1003-8 MSR1002-4 MSR1003-8 LED description Appendix B LEDsPanel LEDs State DescriptionSERIAL0 Appendix C Slot arrangement Support and other resources Contacting HPRelated information Conventions Convention DescriptionNetwork topology icons Index E G I L M N P R S T V W

Related manuals

Manual 8 pages 47.39 Kb